GE Vivid q N Service Manual page 551

GE
D FQ091019, R
IRECTION
8-3-3-5-1 Preparation Procedure
1) Press the PCMCIA slot-flap open and hold it down as shown in
2.) Place the adaptor bracket in position as shown on the right in figure
against the Vivid q N chassis.
NOTE: Figure 8-54
the PCMCIA slot.
Figure 8-54 Rear View of the Vivid q N Scanner after SATA BEP Installation
3.) Connect the control panel/keyboard cable (if previously removed from an ATA BEP; see
8-51) to the SATA BEP.
Proceed to install the SATA BEP as described in the next procedure.
8-3-3-5-2 BEP Installation
1) Carefully return the new BEP to the original position on the Bottom Assembly - refer to
on page
NOTE: When replacing the BEP or Hard Disk, one must either obtain new access codes that will fit the
system ID which is programmed on the BEP, or program the BEP system ID to fit the access
codes already registered in the Hard Disk. Only qualified personnel should perform these tasks.
2.) Check that the BEP is seated correctly then return and fasten the four screws (previously removed)
to secure the BEP to the Bottom Assembly - refer to
3.) Re-connect all the cables to the BEP:
Proceed as follows (refer to
a.) Re-connect the Speaker-to-BEP power cable
b.) Re-connect the Fan-to-BEP power cable.
c.) Re-connect the HVPS-to-BEP power cable.
d.) Re-connect the BEP-to-RFI Flex cable.
e.) Re-connect the LCD Flex ribbon cable (carefully push back and secure the two connector
4.) Return and fasten the two securing nuts previously removed (one on each side of the VGA
Connector, located on the Vivid q N rear panel), as shown
5.) Return the Control Panel and Keyboard, as described in the
Installation Procedure" on page
6.) Return the Hard Disk, as described in the
2
EVISION
shows a view from the rear of the Vivid q N showing the adaptor bracket closing off
Hard Disk shown without
its retaining screws
8-43.
latches).
Chapter 8 - Replacement Procedures
VGA Connector
Figure 8-47 on page 8-41):
8-12.
"Hard Disk Installation Procedure" on page
V
IVID Q
Figure 8-53.
Figure 8-52
Adaptor Bracket
(external view)
Figure 8-48 on page 8-42.
Figure 8-46.
"Control Panel and Keyboard
N S M
ERVICE ANUAL
and press it firmly
Figure
Figure 8-50
8-7.
8-45