GE Vivid q N Service Manual page 514

GE
D FQ091019, R
IRECTION
8-2-3-5-1 Formatting the Hard Disk
1.) Insert the Format Utility disk into the CD drive and boot up the system.
The following sequence of screens is displayed:
2.) Type the password: "geulsservice" and press Enter.
The following message is displayed
The following window displays:
3.) Press any key.
The system ejects the CD.
4.) Remove the CD from the CD drive.
5.) Insert the appropriate software installation CD into the CD drive.
The following options are displayed:
NOTE: If you need to abort the process at this stage, prior to formatting, do so by pressing the On/Off
switch and holding down for a few seconds until the system shuts down.
6.) Select the appropriate formatting action corresponding with your system's software installation.
8-8
2
EVISION
Section 8-2 - External Component Replacement Procedures
V N S M
IVID Q ERVICE ANUAL