Wiring Of I/O Module And External Device; Wiring Of Spring Clamp Terminal Block - Mitsubishi Electric NZ2GN2S1-16D User Manual

6.9

Wiring of I/O Module and External Device

Wiring of spring clamp terminal block

Wire to be used
The following table describes the wire to be connected to the spring clamp terminal block.
Diameter
22 to 16 AWG
Applicable solderless terminal
The following table lists the applicable solderless terminal.
Product Terminal shape
name
Bar solderless Ferrule (with insulation
terminal sleeve)
Ferrule (without
insulation sleeve)
*1 When using a solderless terminal with an insulation sleeve, select the terminal whose applicable wire size is 0.75 or smaller.
Installing or removing the terminal block
The following procedures show how to install and remove the terminal block.
■Lock and release lever positions
To make it easy to install and remove the terminal block, a three-stage positioning stopper is attached so that the lever does
not freely turn around.
When installing or removing the terminal block, turn the lever to the lock or release lever position.
View of right side of I/O module: When pulling out the terminal block
(2)
(1)
View of right side of I/O module: When insertion of the terminal block is
complete
(1)
(2)
6 INSTALLATION AND WIRING
136
6.9 Wiring of I/O Module and External Device
Type
Stranded
Model
AI0.34-10TQ
AI0.5-10WH
AI0.75-10GY
A0.5-10
A0.75-10
A1.0-10
A1.5-10
Material
Copper
Applicable wire Bar solderless terminal
*1
size tool
0.34 CRIMPFOX6
0.5
0.75
0.5
0.75
1.0
1.5
1.
Release lever position
This lever position shows the state in which the terminal
block (1) has been completely pulled out from the I/O
module. Turn from the locking lever position to the release
lever position (2) and lift the terminal block from the I/O
module.
2.
Lock lever position
This position shows the state in which the terminal block (1)
completely fits the I/O module. Check the lock lever position
(2) and pull the terminal block lightly to check that the I/O
module completely fits the terminal block.
Temperature rating
75 or more
Contact
PHOENIX CONTACT GmbH
& Co. KG