Mitsubishi Electric NZ2GN2S1-16D User Manual page 22

I/O module (waterproof module)
Item
Operating ambient temperature
Storage ambient temperature
Operating ambient humidity
Storage ambient humidity
Vibration resistance
Shock resistance
Operating atmosphere
*2
Operating altitude
Installation location
*4
Overvoltage category
*5
Pollution degree
Equipment class
*1 Only when all necessary waterproof connectors and caps have been installed and the indicator cover for the IP address/station number
setting switches and the function setting switches has been properly tightened with screws, the module is compliant with IP67. For the
tightening torque range of the cover screws for the switches, refer to the following.
Page 117 Indicator cover of the I/O module (waterproof module),Page 150 Attaching Waterproof Caps
*2 Do not use or store the I/O module (waterproof module) under pressure higher than the atmospheric pressure of altitude 0m. Doing so
may cause malfunction.
*3 If the environment satisfies the operating ambient temperature, operating ambient humidity and other conditions, the module can be
used even outside the control panel.
*4 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical power
distribution network and the machinery within premises. Category  applies to equipment for which electrical power is supplied from
fixed facilities. The surge voltage withstand level for the equipment with the rated voltage of 300V or less is 2500V.
*5 This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is used.
Pollution degree 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
For compliance with the EMC Directive, refer to the following:
Page 246 EMC and Low Voltage Directives
3 SPECIFICATIONS
20
3.1 General Specifications
Specifications
0 to 55
-25 to 75
*1
Compliant with IP67
5 to 95%RH, non-condensing

Compliant with JIS
B 3502 and IEC
61131-2
Under intermittent
vibration
Under continuous
vibration
Compliant with JIS B 3502 and IEC 61131-2 (147m/, 3 times each in X, Y, and Z directions)
No corrosive gases, flammable gases, less conductive dust
0 to 2000m
*3
Inside a control panel
 or less
2 or less
Class 
Frequency Constant
acceleration

5 to 8.4Hz
8.4 to 150Hz 9.8m/

5 to 8.4Hz
8.4 to 150Hz 4.9m/
Half amplitude Number of sweeps
3.5mm 10 times each in X,
Y, and Z directions


1.75mm
