Mitsubishi Electric NZ2GN2S1-16D User Manual page 245

Output Y OFF information clear request
■Device number
Name
Output Y OFF information clear request
■Description
This remote register is used to clear Output Y OFF information Y (RWrE, RWrF). ( Page 176 Output OFF information)
■Output Y OFF information clear request Y0 to YF (RWwE)
b15 b14 b13 b12
YF YE YD YC
Off: Output Y OFF information is not cleared.
On: Output Y OFF information is cleared.
■Output Y OFF information clear request Y10 to Y1F (RWwF)
b15 b14 b13 b12
Y1F Y1E Y1D Y1C
Off: Output Y OFF information is not cleared.
On: Output Y OFF information is cleared.
Synchronization output timing setting
■Device number
Name
Synchronization output timing setting Y
■Description
When the synchronization cycle timing control mode is used, set the output timing relative to the synchronization cycle start
timing.
Set the timing to change the output from OFF to ON, or from ON to OFF in one synchronization cycle.
If the values set in Synchronization output timing setting Y OFF to ON (RWw10, RWw11, ... , RWw8C, RWw8D) and
Synchronization output timing setting Y ON to OFF (RWw12, RWw13, ... , RWw8E, RWw8F) are the same for one output,
the output does not change.
■Setting value
Set the time (unit: ns) taken from the synchronization cycle start timing to the output change.
The following table lists the setting values.
Setting value
0 to 4294967294 (00000000H to FFFFFFFEH)
4294967295 (FFFFFFFFH)
b11 b10 b9 b8
YB YA Y9 Y8
b11 b10 b9 b8
Y1B Y1A Y19 Y18
Device number
RWwE, RWwF
b7 b6 b5 b4
Y7 Y6 Y5 Y4
b7 b6 b5 b4
Y17 Y16 Y15 Y14
Device number
RWw10 to RWw8F
Description
The output changes at preset timing.
The output does not change.
b3 b2 b1 b0
Y3 Y2 Y1 Y0
b3 b2 b1 b0
Y13 Y12 Y11 Y10
APPX
Appendix 2 Remote Register
A
243