Mitsubishi Electric NZ2GN2S1-16D User Manual page 147

Precautions
■Laying cables
• To connect the cables to the I/O module, securely connect the connector and fix it with screws at two points.
• Place the cables in a duct or clamp them. If not, a dangling cable may swing or inadvertently be pulled, resulting in damage
to the module or cables or malfunction due to poor contact.
■40-pin connector
• 40-pin connectors (A6CON) must be crimped or pressed with tools specified by the manufacturer, or must be correctly
soldered. Incomplete connections may cause short circuit, fire, or malfunction.
• For wires to be connected to 40-pin connectors (A6CON), use copper wires with the temperature rating of 75 or more.
To ensure that this product complies with the EMC Directive and the Low Voltage Directive, refer to the
following.
Page 246 EMC and Low Voltage Directives
Even though the compliance with the EMC Directive and the Low Voltage Directive is not required, configuring
a system that complies with the EMC Directive may reduce effects of the external noise.
6 INSTALLATION AND WIRING
6.9 Wiring of I/O Module and External Device
6
145