Mitsubishi Electric NZ2GN2S1-16D User Manual page 145

■For A6CON2
The following table shows the specifications of the FCN-363T-T005/H to be used for the A6CON2.
Applicable wire size Cross-section area of
the wire
24 AWG 0.20 to 0.24
26 AWG 0.13 to 0.16
28 AWG 0.08 to 0.096
For wiring of the A6CON2, a special tool is required.
For how to use or adjust the tool, contact FUJITSU COMPONENT LIMITED.
■For A6CON3
For wiring of the A6CON3, special tools are required.
For how to use or adjust the tools, contact FUJITSU COMPONENT LIMITED.
The following figure shows the array of terminals for flat cables. (a view from the outlet of a 40-pin connector)
A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12 A13 A14 A15 A16 A17 A18 A19 A20
B1 B2 B3 B4 B5 B6 B7 B8 B9 B10 B11 B12 B13 B14 B15 B16 B17 B18 B19 B20
5.
Place the body in one of the cover and insert the fixing
screws into the screw holes. After that, fit the other
cover on the body.
6.
Tighten the four screws.
Crimp height Sheath outside
diameter
1.2 or less
1.25 to 1.30
1.2 or less
1.20 to 1.25
1.2 or less
1.15 to 1.20
1.
Check the terminal layout and crimp the wires to the
connector.
6.9 Wiring of I/O Module and External Device
Stripping length
3.0 to 4.0
3.0 to 4.0
3.0 to 4.0
6 INSTALLATION AND WIRING
6
143