Mitsubishi Electric NZ2GN2S1-16D User Manual page 168

Input time acquisition control
The time when an input has changed can be acquired by using the input time acquisition control. Select a type of input
change (rising edge or falling edge) to be acquired by setting ON/OFF selection flag (RWw4, RWw5).
 Set a type of input change (rising edge or falling edge) for ON/OFF selection flag (RWw4, RWw5).
 The I/O module sends the following information to the master station, at the third synchronization cycle from the detection
of input change set in ON/OFF selection flag (RWw4, RWw5).
• Input time information X (RWr10 to RWr8F): Time when the input change has been detected
• Input ON/OFF information (RWr4, RWr5): The type of input change (rising edge or falling edge) that has been detected at
the synchronization cycle same as the time stored in Input time information X (RWr10 to RWr8F)
 ON/OFF selection flag X0: The falling edge is set.
 The falling edge has been detected at 20:00, July 24th, 2020.
 Input time information X0: 20:00, 7/24/2020, Input ON/OFF information X0: Falling edge
I/O module
(1) Synchronization cycle
(2) Input
(3) Operation
(4) Output
(5) Falling edge is monitored.
8 FUNCTIONS
166
8.3 CC-Link IE TSN Network Synchronous Communication Function
(1)
Scan program
Synchronization
control interrupt
(2) (3) (4)
program
External input X0
(Status of the X0
OFF
terminal)
Monitoring input
change by the I/O
module
(2) (3) (4) (2) (3) (4)
ON
Ô
Ò
(2) (3) (4) (2) (3) (4) (2) (3) (4)
Ö
OFF
Õ
(5)
(2) (3) (4)
Ó