Mitsubishi Electric NZ2GN2S1-16D User Manual page 165

Synchronization output timing setting control
This control changes an output status according to the timing that is set based on the synchronization cycle start timing.
 Set the following for each synchronization cycle.
• Synchronization output timing setting Y0 OFF to ON: Set the timing to change the output from off to on.
• Synchronization output timing setting Y0 ON to OFF: Set the timing to change the output from on to off.
 Synchronization output timing setting Y0 OFF to ON: 200s, Synchronization output timing setting Y0 ON to OFF: Do not
change the output from on to off.
 Synchronization output timing setting Y0 OFF to ON: Do not change the output from off to on, Synchronization output
timing setting Y0 ON to OFF: 800s
 Synchronization output timing setting Y0 OFF to ON: Do not change the output from off to on, Synchronization output
timing setting Y0 ON to OFF: Do not change the output from on to off.
 The output module performs the output control according to the settings, at the second synchronization cycle from the
setting.
I/O module
(1) Synchronization cycle
(2) Input
(3) Operation
(4) Output
(5) The output has been turned on 200s later.
(6) The output has been turned off 800s later.
Scan program
Synchronization
control interrupt
(2) (3) (4)
program
External output Y0
(Status of the Y0 OFF
terminal)
8.3 CC-Link IE TSN Network Synchronous Communication Function
(1)
(2) (3) (4) (2) (3) (4)
Ò
Ô
Ò
Ó
(2) (3) (4) (2) (3) (4) (2) (3) (4)
Ò
Õ
ON
(5) (5) (6)
Ö
8 FUNCTIONS
8
163