Table of Contents
Advertisement
Operating Guide | VACON® NXS/NXP Air-cooled
8. Attach the cable cover
12.5 Tightening Torques for Cover
9. Attach the grounding clamps for control cable with 3 pieces of M4x16 screws delivered in the accessories bag. Use these clamps to
ground the control cables. Connect the control cables.
Illustration 27:
10. Attach the cover of the drive. For the tightening torques of the screws, see
that the control cables or the cables of the AC drive are not caught between the frame and the cable cover.
6.5.3 Installing the Cables, FR7/FI7
Context:
Follow these instructions to install the cables and cable accessories.
For information on how to comply with the UL regulations in cable installation, see
If it is necessary to connect an external brake resistor, see VACON
Resistor
Connection.
Prerequisites:
Make sure that the delivery contains all necessary components. For the installation, the contents of the accessories bag is needed, see
4.1 Checking the
Delivery.
70 | Danfoss A/S © 2020.02
FR4-FR6/FI4-FI6
Screws.
12.5 Tightening Torques for Cover
6.1.2 UL Standards on
®
Brake Resistor Manual. See also
Electrical Installation
Screws. Make sure
Cabling.
8.7.8.2 Setting the Internal Brake
AQ275638903263en-000301 / DPD00910
Advertisement
Table of Contents
