Table of Contents
Advertisement
Operating Guide | VACON® NXS/NXP Air-cooled
Procedure
1. To move the cables through grommets, cut them open.
•
Do not cut the grommet openings wider than what is necessary for the used cables.
•
If the grommets fold in when putting the cable, pull the cable back to make the grommets straight.
•
Cable gland can be used if preferred.
2. Attach the grommet and the cable until the frame of the drive goes into the groove of the grommet.
3. To make a 360° connection with the grounding clamp for cable shield, expose the shield of motor cables.
4. Connect the cables. See the correct tightening torques in
A Connect the mains and motor cables. Use the busbar to make the connection.
Danfoss A/S © 2020.02
12.6 Tightening Torques of the
Electrical Installation
Terminals.
AQ275638903263en-000301 / DPD00910| 89
Advertisement
Table of Contents
