Belt Inspection; Pvt Break-In (Drive Belt / Clutches) - Polaris Sportsman 800 EFI 4x4 2012 Service Manual

CLUTCHING

Belt Inspection

1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
3. Belts with thin spots, burn marks, etc., should be
replaced to eliminate noise, vibration, or erratic PVT
operation. See the Troubleshooting Chart at the end
of this chapter for possible causes.

PVT Break-In (Drive Belt / Clutches)

A proper break-in of the clutches and drive belt will
ensure a longer life and better performance. Break in the
clutches and drive belt by operating at slower speeds
during the 10 hour break-in period as recommended (see
Chapter 3 "Engine Break-In Period" for break-in
example). Pull only light loads. Avoid aggressive
acceleration and high speed operation during the break-
in period.
6.12
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.