Drive Belt; Belt Removal; Belt Inspection - Polaris RZR PRO R Service Manual

PVT SYSTEM

DRIVE BELT

BELT REMOVAL

1. Park vehicle on a level surface.
2. Remove seats. On 4-seat models, remove the rear
seats.
3. Remove upper and lower rear close-off panels.
w
4. Loosen hose clamp
hose.
5. Remove five fasteners
turn latches, and remove the outer PVT cover.
6. Remove the drive belt.

BELT INSPECTION

1. Inspect belt for hour glassing (extreme circular wear
in at least one spot and on both sides of the belt).
Hour glassing occurs when the drive train does not
move and the drive clutch engages the belt.
2. Inspect belt for loose cords, missing cogs, cracks,
abrasions, thin spots, or excessive wear. Compare
belt measurements with a new drive belt. Replace if
necessary.
6.4
and remove the PVT intake
e
, disengage remaining 1/4
3. Belts with thin spots, burn marks, etc., should be
replaced to eliminate noise, vibration, or erratic PVT
operation. See the Troubleshooting Chart at the end
of this chapter for possible causes.
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.