Polaris Sportsman 800 EFI 4x4 2012 Service Manual page 124

ENGINE
39. Install water pump cover (R) with new O-ring seal.
Torque bolts to specification in proper sequence
(See front of this chapter).
Water Pump Housing Bolt:
96 in-lbs (10.85 Nm)
*Torque in proper sequence
40. Sparingly apply Starter Drive Grease (PN 2871423)
to the starter drive. Install the starter bendix.
NOTE: There are thrust washers on both sides
of starter drive.
41. Install stator assembly (S) and bolts. Torque bolts to
specification.
3.64
42. Install the wire hold down bracket (T). Install two new
wire hold down bolts. New bolts contain patch-lock.
Torque bolts to specification, following the proper bolt
torque sequence. Coat the stator wire grommet (U)
with Nyogel Grease (PN 2871329).
NOTE: Verify stator wires are routed properly
under the wire hold down bracket.
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
Stator Assembly Bolt:
96 in-lbs (10.85 Nm)