11. Inspect roll cage (B) sliding surface. This surface
must be clean and free of nicks, burrs or scratches.
Inspect the H-springs, but do not remove them
from the roll cage.
12. Inspect the armature plate for a consistent wear
pattern. Uneven wear of the armature plate indicates
a warped plate, which may cause intermittent
operation.
NOTE: See "FRONT GEARCASE DIAGNOSIS"
later in this chapter for more details.
13. Inspect the magnetic coil (A) in the outer cover plate
14. Remove the bolts retaining the input shaft cover and
9924864 - 2012-2014 SPORTSMAN 800 / 6X6
© Copyright 2013 Polaris Sales Inc.
assembly. Inspect the backlash pad (B) for excessive
wear.
NOTE: See "FRONT GEARCASE DIAGNOSIS"
later in this chapter for more details on the coil.
The backlash for the centralized hilliard is set at
the factory. No adjustment is required, unless the
front cover is replaced, or the back lash pad
screw is removed. See the "FRONT GEARCASE
ASSEMBLY" procedure later in this chapter for
details on backlash setting.
pinion gear assembly.
FINAL DRIVE
7
7.13