Step 2: Access The Setup Wizard; Step 3: Ensure That All Hardware Is Installed; Step 4: Set Up The Library Network Configuration - IBM System Storage TS3310 Setup And Operator Manual

Step 2: Access the Setup Wizard

Important: If at any point you touch Cancel while in the Setup Wizard, the Setup
1. If the Setup Wizard: Welcome screen does not display automatically, select
2. After reading the information on the screen, touch Begin.

Step 3: Ensure that all Hardware is Installed

1. Read the Hardware Installation screen.
2. Ensure that all tape drives and the customer-supplied Ethernet cable are
3. If the drives and Ethernet cable are installed, touch Next to continue.

Step 4: Set up the Library Network Configuration

Read "Modifying Network Settings" on page 5-1 before beginning this step.
Important: You will not be able to access the library remotely until the network
Touch No if you do not know your network settings and to continue configuring
your library.
To set up the network configuration:
1. Determine your network settings (IP Address, Default Gateway, and Subnet
2. Touch Yes to begin configuring the library network.
3. Choose a name for your library.
4. Touch the Library Name text box to access the alphanumeric keyboards.
5. Using the alphanumeric keyboards, enter the name into the Library Name
6. Select Dynamic Host Configuration Protocol (DHCP) to have the library
Wizard: Cancel screen appears. The screen is dynamically updated to
indicate what the current configuration of the library is, including any
settings that have been applied thus far in the Wizard. Touching
Cancel on the Cancel screen navigates you back to the last accessed
screen in the Setup Wizard. Touching OK applies the current settings
and returns you to the Home Page screen.
Setup → Setup Wizard to display the Welcome screen.
installed.
settings are applied. Library firmware can only be updated using the
remote Web User Interface.
Mask) and record this information on the Appendix D, "Library Configuration
Form," on page D-1.
field.
Note: The library name can be a maximum of 12 alphanumeric characters. Any
letters used in the library name must be lowercase.
network setting automatically configured. To configure your network manually,
enter the following network settings:
v IP Address - the Internet protocol (IP) address of the library
v Default Gateway - the IP address of the default gateway for your portion of
the Ethernet network
Chapter 7. Configuring the Library
7-3