IBM System Storage TS3310 Setup And Operator Manual page 278

Figure 12-16. Library Control Blade (LCB)
Replacing the Library Control Blade (LCB)
Important: When handling the LCB, you must wear an ESD anti-static wrist
1. Unpack the new LCB and carefully lay it on a clean, flat surface.
2. Locate the empty LCB slot on the rear panel of the control module (CM). Then,
3. Grasp the pair of latches near the top and bottom of the LCB ( 3 in
12-20
TS3310 Tape Library Setup and Operator Guide
strap, or touch the library frame to discharge any static electricity in
your body. Do not handle the LCB without taking appropriate ESD
precautions.
Important: DO NOT touch any components on the LCB firmware board (see
Figure 12-16). Hold it by the metal cover and support it by the
metal ground plane only.
carefully line up the new LCB board along the guide slots, and gently slide it
into the control module until the connector seats.
Important: As the LCB begins to slide into the control module, be sure to
support the firmware board from underneath, being careful to
touch only the metal cover and the ground plane along the
bottom edge.
Figure 12-17 on page 12-21) by pushing them in until they click into place.