Installing Library Components Removed For Weight Reduction; Releasing The Picker Assembly Lock - IBM System Storage TS3310 Setup And Operator Manual

1. IMPORTANT: Ensure that the front and rear gear racks are in the down
2. Feel the junction of the gear racks between each library module, front and rear.
3. Manually raise the picker assembly while you release the lock mechanism ( 1
Figure 3-27. Releasing the picker assembly lock mechanism
4. Release the picker assembly and observe it as it slowly drops to the bottom of

Installing Library Components Removed for Weight Reduction

At this point in the installation procedure, reinstall the drive sleds and power
supplies that were removed for weight reduction.
(operating) position (see 1 in Figure 3-19 on page 3-21).
Ensure that there are no gaps between the gear racks before you release the
picker assembly lock mechanism.
in Figure 3-27).
1
the library. It should move smoothly as it travels from one module into the
other.
Note: If the picker jumps or bumps noticeably as it travels from one module
into the other, an error is likely to occur when the library is powered on.
Follow the instructions in "T083: Robot Assembly not level" on page
11-31 to correct the problem.
Chapter 3. Installing A New Library in a Rack
3-29