Replacing A Control Module In A Standalone Or Rack-Mounted Library (14U Or Larger); Alignment Pin And Front Thumb Screw - IBM System Storage TS3310 Setup And Operator Manual

Figure 12-4. Alignment pin and front thumb screw
10. Loosen the front thumb screws.
11. Lift and rotate the control module alignment pin to lock the pin in an up
12. With a person standing on each side of the control module, pull it out of the
13. Place the control module on a sturdy work surface.
Replacing a Control Module in a Standalone or Rack-mounted
Library (14U or larger)
9. Open the I/O Station door then the Access Door of the control module to
expose the control module alignment pin (
2
screws ( in Figure 12-4) behind the Access Door and behind the I/O Station
door.
position.
rack.
1. Ensure that the front and rear gear racks are in the upper position. (see 2 in
Figure 12-5 on page 12-8.
1 2
1
in Figure 12-4) and front thumb
Chapter 12. Add, Remove, and Replace Procedures
12-7