Powering On The Library - IBM System Storage TS3310 Setup And Operator Manual

2. Install one end of one of the module-to-module communication cable in the
3. Install one end of the other module-to-module communication cable in the
4. Install a module communication terminator in the lower receptacle of the
5. Install one end of the customer-supplied Ethernet cable in the Library Control
6. For each drive, install one end of the drive host fibre cable in a drive in the
7. Connect one end of the power cord in the receptacle of a power supply in your
8. Continue with "Powering ON the Library."

Powering ON the Library

1. Turn the switch on each power supply (
2. Push the power button on the front panel of the library. A green LED to the left
3. Wait for the library to initialize. This will take approximately 10 minutes.
4. When initialization is complete, configure the library. Read the information in
lower receptacle of the upper module of your library, then install the other end
in the upper receptacle of the middle module of your library ( 2 in Figure 3-34
on page 3-36).
lower receptacle of the middle module of your library, then install the other
end in the upper receptacle of the bottom module of your library ( 2 in
Figure 3-34 on page 3-36).
bottom module of your library ( 1 in Figure 3-34 on page 3-36).
Blade Ethernet port, then connect the other end of the cable to your network
( 3 in Figure 3-34 on page 3-36).
library, then connect the other end of the cable to your network ( 10 in
Figure 3-34 on page 3-36). Repeat this for every drive in your library.
library, then connect the other end of the cord to your power source. Repeat
this for every power supply in your library ( 6 , 7 , and 9 in Figure 3-34 on
page 3-36).
ON (|) position.
of the power button indicates that the power is ON.
Note: If the operator panel does not initialize, check all cable connections, and
ensure that all doors are tightly closed and all power supply switches are
in the ON position. Then, repeat steps 1 and 2. If the panel still does not
initialize, see "Diagnosing a Problem" on page 10-2.
Chapter 5, "Configuration Planning," on page 5-1 and Chapter 6, "User
Interfaces," on page 6-1 before proceeding to Chapter 7, "Configuring the
Library," on page 7-1.
4
in Figure 3-31 on page 3-32) to the
Chapter 3. Installing A New Library in a Rack
3-37