Installing Library Components Removed For Weight Reduction (For Rack Installations Only); Replacing A Drive Sled; Releasing The Picker Assembly Lock - IBM System Storage TS3310 Setup And Operator Manual

Figure 4-18. Releasing the picker assembly lock mechanism
|
|
|
|
|
|
|
|
Installing Library Components Removed for Weight Reduction (for
|
Rack Installations Only)
|
|
|
|
|
|

Replacing a Drive Sled

|
|
|
|
4-18
TS3310 Tape Library Setup and Operator Guide
1
4. Release the picker assembly and observe it as it slowly drops to the bottom of
the library. It should move smoothly as it travels from one module into the
other.
Note: If the picker jumps or bumps noticeably as it travels from one module
into the other, an error is likely to occur when the library is powered on.
Follow the instructions in "T083: Robot Assembly not level" on page
11-31 to correct the problem.
Follow these steps to install the components removed earlier for weight reduction.
1. Install the drive sleds in their original locations (see Replacing a Drive Sled).
Refer to the notes you made earlier on drive position.
2. Install the power supplies beginning with the left position in each library unit
containing drives (see Replacing a Power Supply).
Attention: NEVER install a drive sled when a cartridge is in the drive in the eject
position. Remove the cartridge first.