Setup Wizard - IBM TotalStorage DS300 Best Practices Manual

percentage
This is a number followed by a '% ' sign. Percentages allow both integers and
numbers with decimal points.
relative_period
This defines a period of time that is usually added to or subtracted from a time or
date.
Note: Application of the relative_period parameter is described in the relevant
command section of this appendix.
The relative_period is expressed as a number followed by an upper or lower case
letter which indicates the units to which the number refers. The letters are:
S
M
H
D
W
For example:
90m (or 90M) expresses 1 hour 30 minutes.
3h (or 3H) expresses 3 hours
Only a single value can be entered.
When the relative period is to be subtracted, the sign of the relative_period
parameter is ignored. When the relative period is to be added, the sign of the
relative_period parameter is used; however, an error is generated if it is illegal to
have a negative relative period for that command.
A.3 Setup Wizard
The Setup Wizard runs if the system is in factory default state when the CLI is
started. You can also run it with the setup command. The Setup Wizard helps
you enter the information required to connect the system to a local network.
Seconds
Minutes
Hours
Days
Weeks
Appendix A. Command line interface reference
573