Gear Racks And Gear Rack Locking - IBM System Storage TS3310 Setup And Operator Manual

Figure 12-2. Gear racks and gear rack locking mechanism
1
3
3. Disengage the rear (
racks in the control module. While pinching the gear rack locking mechanism
2
( in Figure 12-2) , push the gear rack up until it locks in place.
4. Unplug the customer-supplied Ethernet cable from the Library Control Blade (
2
in Figure 12-15 on page 12-19).
5. Unplug the module-to-module communication cable from the control module
4
( in Figure 12-15 on page 12-19).
6. Remove the following components from the control module to reduce the
weight of the module.
a. Power supplies (see "Removing/Replacing a Power Supply (Primary and
Redundant)" on page 12-24).
b. Drive sleds (see "Adding/Removing/Replacing a Drive Sled" on page
12-15).
2
1
in Figure 12-2) and front (
Chapter 12. Add, Remove, and Replace Procedures
3
in Figure 12-2) gear
12-5