Configuring The Management Module For Remote Access - IBM BladeCenter Management Module Installation Manual

Configuring the management module for remote access

After you connect the active management module to the network, the Ethernet
port connection is configured in one of the following ways:
v If you have an accessible, active, and configured dynamic host configuration
protocol (DHCP) server on the network, the host name, IP address, gateway
address, subnet mask, and DNS server IP address are set automatically.
v If the DHCP server does not respond within 2 minutes after the port is
connected, the management module uses the factory-defined static IP
address and default subnet address.
Either of these actions enables the Ethernet connection on the active
management module.
Make sure your computer is on the same subnet as the management module;
then, use your Web browser to connect to the management module (see
"Starting the management and configuration program" on page 29 for more
information). In the browser Address field, specify the IP address the
management module is using:
v If the IP address was assigned through a DHCP server, get the IP address
from your network administrator.
v The factory-defined static IP address is 192.168.70.125, the default subnet
address is 255.255.255.0, and the default host name is MMxxxxxxxxxxxx,
where xxxxxxxxxxxx is the burned-in medium access control (MAC) address.
The MAC address is on a label on the management module, below the IP
reset button.
OK
LINK
TX/RX
MAC address
IP
Chapter 4. Configuring the management module
27