Home Sensor On Inner Side Of Bottom Cover; Bottom View Of Picker Assembly Lock - IBM System Storage TS3310 Setup And Operator Manual

Figure 4-9. Home sensor on inner side of bottom cover
|
|
|
|
|
1
Figure 4-10. Bottom view of picker assembly lock mechanism
|
|
|
|
|
|
|
1
Important: Ensure that the picker lock mechanism ( 1 in Figure 4-10) is
engaged as shown. This will prevent the picker mechanism from
falling out of the bottom of the 5U control module when it is
returned to the upright position without a bottom cover installed.
4. Return the 5U control module to the upright position.
5. Ensure that the front and rear gear racks of both the control module and the
expansion module are locked in the upper position (see 2 in Figure 3-19 on
page 3-21).
6. Turn the expansion module on its side and install the bottom cover, using the 5
- T10 Torx screws.
7. Return the expansion module to the upright position.
Chapter 4. Installing a New Standalone Library on a Desktop
4-11