Installation And Setup Instructions; Unpacking The N3240 Series Filer - IBM N3240 Installation And Setup Instructions

Installation and setup instructions

Use these instructions to install and set up your N3240 series filer.

Unpacking the N3240 series filer

Use these instructions to unpack the N3240 filer.
Important: If your system was shipped already assembled and cabled in a rack, go directly to "Setting
up and booting the system in Data ONTAP 7-Mode" on page 11 or "Setting up and booting the system in
Clustered Data ONTAP" on page 12 depending on your configuration.
Each N3240 system enclosure ships with an accessories kit and set-up kit containing documentation and
hardware parts for installing your system. The quantity of hardware parts is determined by your system
configuration and requirements.
Each shipment container includes the following contents:
v N3240 series system enclosure
v N3240 series system bezel
v N3240 Installation and Setup Instructions
v General information kit, containing warranty, safety, and environmental information
v Software license
32-55 kg (70.5-121.2 lbs)
1. Remove the foam hardware protectors and the plastic surrounding the system.
2. Place the storage system on a table.
Contents for each N3240 model
The N3240 is a single-enclosure high availability (HA) capable system. Each N3240 model also ships with
at least one envelope with the software End User License Agreement (EULA) and license keys. The
following list describes the contents of the shipping packages included with the N3240 model:
v 2 console adapters, RJ-45 to DB-9 (one per controller module)
v 4 cable management arms (two per controller node)
v 1 ESD wrist strap
v 4 power cables
v 2 serial null modem cables (one per controller)
v 3U IBM rail kit
v 1 set of IBM publications
© Copyright IBM Corp. 2013
CAUTION:
The weight of this part or unit is more than 45.4 kg (100 lb). It takes specially
trained persons, a lifting device, or both to safely lift this part or unit.
1