Rack Mounted To Desktop Library Conversion; Removing The Rack Ears On A Control - IBM System Storage TS3310 Setup And Operator Manual

2. Disconnect library cables.
3. Remove the library foot pads. For instructions, refer to "Removing/Installing
4. Install the library in the rack. For instructions, refer to Chapter 3, "Installing A
5. Cable the library. For instructions, refer to "Cabling the Library" on page 3-32.
6. Perform "Returning a Library or Library Module to Normal Operations after

Rack Mounted to Desktop Library Conversion

Complete the following to convert your library from a rack mounted unit to a
desktop unit.
1. Perform "Preparing a Library or Library Module for Repairs" on page 12-2.
2. Disconnect library cables.
3. Reduce library weight. For instructions, refer to "Reducing Weight" on page
4. Remove rack ears from all library modules.
2
Figure 12-21. Removing the rack ears on a Control Module
a. Disconnect all power cords from the power source and the library.
b. Disconnect all drive cables.
c. Disconnect the Ethernet cable from the Library Control Blade.
Library Foot Pads" on page 12-28.
New Library in a Rack," on page 3-1.
Repairs" on page 12-2.
a. Disconnect all power cords from the power source and the library.
b. Disconnect all drive cables.
c. Disconnect the Ethernet cable from the Library Control Blade.
3-5.
a. Grasp the I/O Station handle and pull it toward you until it locks in the
open position.
b. Remove the right rack ear ( 2 in Figure 12-21).
1) Loosen the right rack ear thumb screws.
2) Remove the right rack ear.
c. Remove the left rack ear ( 3 in Figure 12-21).
1) Open the left door of the library unit slightly.
3
Chapter 12. Add, Remove, and Replace Procedures
4
12-27