Enabling The Picker Assembly - IBM System Storage TS3310 Setup And Operator Manual

Figure 4-17. Rear thumb screws
|
|
|
|
|

Enabling the Picker Assembly

|
|
|
|
|
|
|
|
|
|
|
13. IMPORTANT: Lower the gear racks into the down (operating) position. See
1 in Figure 3-19 on page 3-21.
14. Repeat this procedure for each module in your library.
15. Store the installation lifting sling in a secure location for possible future use.
Important: Picker assembly damage or library accessor errors can occur if the front
or rear gear racks are not engaged properly.
1. IMPORTANT: Ensure that the front and rear gear racks are in the down
(operating) position (see 1 in Figure 3-19 on page 3-21).
2. Feel the junction of the gear racks between each library module, front and rear.
Ensure that there are no gaps between the gear racks before you release the
picker assembly lock mechanism.
3. Manually raise the picker assembly while you release the lock mechanism ( 1
in Figure 4-18 on page 4-18).
1
Chapter 4. Installing a New Standalone Library on a Desktop
4-17