Drive Sled Slot - IBM System Storage TS3310 Setup And Operator Manual

Replacing a Drive Sled
Attention: NEVER install a drive sled when a cartridge is in the drive in the eject
position. Remove the cartridge first.
Figure 12-13. Control Module Drive Sled
1. Align the drive sled with the guide rails and guide slots along the tracks (
Figure 12-14. Drive sled slot
2. Tighten the two thumb screws (
3. Reconnect the drive sled cable.
in Figure 12-14) in the open drive sled slot (
5
handle ( in Figure 12-12 on page 12-16) and slowly slide the drive sled into
the CM, while supporting the drive sled from underneath.
Note: The thumb screws must be aligned with the screw holes in the module.
If they are not aligned, the drive sled was not inserted correctly.
3
drive sled in place by turning them clockwise.
a. For a SCSI drive sled, plug the cable and terminator into the drive sled.
Tighten the thumb screws that hold the SCSI cable (
page 12-16 shows the SCSI receptacle) and terminator (
on page 12-16) in place by turning them clockwise.
2
in Figure 12-14). Grasp the
2
2
in Figure 12-12 on page 12-16) that hold the
Chapter 12. Add, Remove, and Replace Procedures
1
3
1
4
in Figure 12-12 on
3
in Figure 12-12
12-17