Verifying Front And Rear Gear Racks Alignment - IBM System Storage TS3310 Setup And Operator Manual

3. Replace the left rack ear ( 3 in Figure 12-9 on page 12-12).
4. Repeat this process for all units in the library, if necessary.

Verifying Front and Rear Gear Racks Alignment

In order for the picker to move from one unit to the next in a multi-module library,
the front (
12-14) gear racks in the control module must be properly aligned with the gear
racks in the expansion module.
a. At the bottom right of the I/O Station position on each library unit, there is
a slot ( 2 in Figure 12-9 on page 12-12). Insert the right rack ear into the
slot.
b. Position the right rack ear flush with the rack rail.
c. Install and tighten the right rack ear thumb screws.
a. Open the left door of the library unit slightly.
a. Grasp the hinged side of the door and, while pulling on the door, push
right to expose the slot for the left rack ear.
b. Insert the left rack ear into the slot ( 4 in Figure 12-9 on page 12-12).
c. Position the left rack ear flush with the rack rail.
d. Install and tighten the left rack ear thumb screws.
3
in Figure 12-10 on page 12-14) and rear (
1
Chapter 12. Add, Remove, and Replace Procedures
in Figure 12-10 on page
12-13