Panasonic LP-GS Series Serial Communication Command Manual page 82

Name Omit
Bold line width Y
Font No. Y
Character
Y
spacing type
Character
(Y)
arrangement
Start angle Y
Arc radius Y
Character
spacing angle
Y
or
Arc angle
Linefeed
Y
spacing
Laser power
Y
correction
Scan speed
Y
correction
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Object No. = 1, X-position = -10, Y-position = 2.5, Character height = 4.5, Character width = 4,
Horizontal alignment = 0, Vertical alignment = 3, Bold line width = 0.3, Font No. = 2,
Character spacing type = 0, Character arrangement = 0, Rotation angle = -180, Character spacing = 4.2,
Linefeed spacing = 5, Laser power correction = 120, Scan speed correction = 80
• Setting
Transmission data
• Readout
Transmission data
Response data
82
Data
length Data contents
[byte]
Max. 5* "0.000"–"6.000" [mm]
Max. 2* "01"–"50"
"0": Fixed spacing
"1": Proportional 1
1 "2": Proportional 2
"3": Proportional 3
"4": Justify
"2": Arc Outside
1
"3": Arc Inside
Max. 8* "-180.000"–"+180.000" [°]
Max. 7* "000.000"–"999.999" [mm]
When character spacing type is "0"–"3":
"-180.000"–"+180.000" [°]
Max. 8*
When character spacing type is "4":
"-360.000"–"+360.000" [°]
Model
LP-GS051(-L)
Max. 7* LP-GS052
LP-RC350S
LP-RF200P
Max. 3* "000"–"999" [%]
Max. 3* "001"–"999" [%]
Max. 97 It is the length including the separator ",".
[STX] STC
[STX] STC
[STX] STC A
ME-LPGS-SR-5
Sets the position specified by the
horizontal alignment to a starting
position, and specifies the angle.
Specifies a character spacing angle
for fixed spacing/proportional, and
an arc angle for justify.
Setting range [mm]
"000.000"–"055.000"
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
The correction ratio is calculated
using the value set at the laser
settings as 100%.
S 1,-10,2.5,4.5,4,0,3,0.3,2,0,0,-180,4.2,5,120,80
R 1 [CR]
0001,-010.000,+002.500,004.500,004.000,0,3,0.300,02,0,0,
-180.000,004.200,005.000, 1 20,080
Remarks
• If you do not make characters
bold, select 0 mm.
• If you make characters bold, set
the bold line width to 1/2 or less
of the character height or width,
whichever is smaller.
[CR]
[CR]