Panasonic LP-GS Series Serial Communication Command Manual page 102

8. When the code type is GS1 DataBar Stacked CC-A/GS1DataBar Limited CC-A and specify its 2D side
settings
Name Omit
Object No.
X-position
Y-position
Rotation angle
Code type
System reserved
value
Number of rows for
2D side
Row height to
module width ratio
for 2D side
Separator height to
module width ratio
Horizontal quiet
zone to module
width ratio for 2D
side
System reserved
value
System reserved
value
2D side human
readable text
2D side laser power
correction
2D side scan speed
correction
102
Data
length
[byte]
– Max. 6* "0000.1"–"1999.1"
Y Max. 8*
"-999.999"–"+999.999" [mm]
Y Max. 8*
Y Max. 8* "-180.000"–"+180.000" [°]
"41": GS1 DataBar Stacked CC-A
(Y) 2
"43": GS1 DataBar Limited CC-A
Y Max. 2* "00" or omit
GS1 DataBar Stacked CC-A
"00": Auto (minimize setting)
"05"–"10", "12" [rows]
Y Max. 2*
GS1 DataBar Limited CC-A
"00": Auto (minimize setting)
"04"–"08" [rows]
Y Max. 5* "01.00"–"10.00"
Y Max. 4* "00.0"–"10.0"
Y Max. 4* "00.0"–"20.0"
Y Max. 4* "00.0" or omit
Y 1 "0" or omit
"0": OFF
Y 1
"1": ON
Y Max. 3* "000"–"999" [%]
Y Max. 3* "001"–"999" [%]
Data contents
ME-LPGS-SR-5
Remarks
• To set the 2D side of the composite
codes, add ".1" after the object
number.
• Only "1" can be specified after the
decimal point.
• Without ".1", the settings are applied
to 1D side of the composite codes.
• It is the center coordinate of the
code.
• The rotation center is the center of
the code symbol.
• For the composite codes, these
settings are applied to both 1D and
2D side.
For the composite codes, this setting is
applied to both 1D and 2D side.
"00": Auto sets the minimum value
depending on the code data settings.
• Specifies the height for one row of
the 2D side.
• Specifies the ratio to the module
width of 1D side.
• Specifies the height of the separator
placed between 1D and 2D.
• Specifies the ratio to the module
width of 1D side.
• Specifies the quiet zone width of the
2D side.
• Specifies the ratio to the module
width of 1D side.
The correction ratio is calculated using
the value set at the laser settings as
100%.