Registered Character Strings: Rks - Panasonic LP-GS Series Serial Communication Command Manual

3-6-8 Registered character strings: RKS

Sets the character string used with the "Registered characters" function that switches characters by I/O input.
⿎ Setting request data
Start
RKS S
code
⿎ Readout request data
Start
RKS R
code
⿎ Response data for readout
Start [Registered character table No.], [Data number], [Registered characters]
RKS A
code
⿎ Data description
Data length
Name
[byte]
Registered
character table 1
No.
Data number Max. 3*
Registered
Max. 18
characters
Total data length Max. 24
* Setting request data are variable length.
Reference
• Refer to "2-3-6 Character data input method" (P.38) for details on the character input method and character types with
input restrictions.
• For response data for readout, the characters input with the one-byte characters are read out in ASCII code. The
characters input with the two-byte characters are read out in the character code, Shift JIS code or GB 2312 code,
selected in the system settings. If any characters which belong to the non-supported character code are in the data, the
readout request cannot be accepted.
⿎ Example of command settings
Condition: Registered character table No. = 2, Data number = 4, Registered characters = abcd, Data number = 11,
Registered characters = efgh
• Setting
Transmission data
Condition: Registered character table No. = 2, Data number = 4, Registered characters = abcd
• Readout
Transmission data
Response data
[Registered character table No.], [Data number], [Registered characters]
(, [Data number], [Registered characters]...)
[Registered character table No.], [Data number]
Max. 5-byte
Data contents
I/O input format
4-bit x 4
8-bit x 2
I/O input format
4-bit x 4
8-bit x 2
The number of input characters
allowed: Max. 9 characters
It is the length including the separator ",".
The maximum value that can be set to one data number.
Character strings for max. 32 sets of data numbers can be set at once.
[STX] RKS
[STX] RKS
[STX] RKS
Max. 24-byte
Setting range
The setting range varies depending on the I/O
"0"–"3"
input format.
"0"–"1"
Setting range
Data number which sets characters. The setting
"000"–"015"
range varies depending on the I/O input format.
"000"–"255"
Specify 0-byte for data length to delete
characters.
S 2,4,abcd,11,efgh
R 2,4 [CR]
A 2,004,abcd [CR]
ME-LPGS-SR-5
(Check
sum)
(Check End
sum) code
(Check
sum)
Remarks
[CR]
End
code
End
code
93