Connecting To External Control Devices And Its Setting Sample - Panasonic LP-GS Series Serial Communication Command Manual

1-4-3 Connecting to external control devices and its setting sample

Connect the two or more laser markers and an external device via a HUB or a router:
Use a HUB (or a rooter) that supports 100BASE-TX/10BASE-T and a cable of Category 5 or higher for the connection.
External controller (PC, etc.)
Example of communication system settings:
Set a separate IP address not to overlap between the laser marker and PC on the network.
IP address
Subnet mask
Default gateway
Command control port
Reference
• When the laser marker is connected the external control device one to one, no HUB is necessary.
Laser marker controller
(Several units connected)
PC Laser marker A
192.168.1.10 192.168.1.5
—
ME-LPGS-SR-5
HUB (or rooter)
Laser marker B
192.168.1.6
255.255.255.0
None
9094
Laser marker C
192.168.1.7
25