Panasonic LP-GS Series Serial Communication Command Manual page 105

Name Omit
Laser power
Y
correction
Scan speed
Y
correction
Linefeed Y
Total data length
* Setting request data are variable length.
Reference
• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negative
response.
• Use the object creation (CRE) command if you want to create new bar code/2D code objects.
• If the character strings of bar code/2D code contain a control code, the control code is not included in the human
readable text.
• For the composite codes, the settings from "character height" are applied to both 1D and 2D side.
• Only when the request data contains the object number with the value after the decimal point, the object number of the
response data contains the value after the decimal point.
⿎ Example of command settings
Condition: Object No. = 1, Relative X-position = 10, Relative Y-position = -5.5, Character height = 3,
Character width = 3, Character spacing = 3, Linefeed spacing = 3.5, Font No. = 2,
Bold line width = 0, Laser power correction = 100, Scan speed correction = 200, Linefeed = 0
• Setting
Transmission data
• Readout
Transmission data
Response data
Data length
Data contents
[byte]
Max. 3* "000"–"999" [%]
Max. 3* "001"–"999" [%]
"0": No linefeed
1
"1": Enable linefeed
Max. 75 It is the length including the separator ",".
[STX] BRV
[STX] BRV
[STX] BRV
ME-LPGS-SR-5
S 1,10,-5.5,3,3,3,3.5,2,0,100,200,0
R 1 [CR]
0001,+010.000,-005.500,003.000,003.000,003.000,
A
003.500,02,0.000, 1 00,200,0
Remarks
• The correction ratio is
calculated using the value set
at the laser settings as 100%.
• For the composite codes,
these settings are applied to
both 1D and 2D side.
Applied only to the 2D code and
2D side of the composite code.
When the code data contains the
linefeed "\n", set whether this
linefeed is applied also to the
human readable text or not.
[CR]
[CR]
105