Layout/Position Adjustment Commands; Object Coordinates: Pos - Panasonic LP-GS Series Serial Communication Command Manual

3-11 Layout/Position Adjustment Commands

3-11-1 Object coordinates: POS

Sets the base position of the marking object.
Reference
• You can use this command as a shortened command consisting only of X-/Y-positions and Rotation angle of the
character/bar code/graphic object settings (STC/BRF/CDC) commands.
• For the point radiation object, the position of the all radiation points set in the specified object number is adjusted by this
command. To specify the position of the each radiation point, use PRD command (point radiation parameters).
⿎ Setting request data
Start
POS
code
⿎ Readout request data
Start
POS
code
⿎ Response data for readout
Start
POS
code
⿎ Data description
Name Omit
Object No. –
X-position Y
Y-position Y
Rotation angle Y
Total data length
* Setting request data are variable length.
⿎ Example of command settings
Condition: Object No. = 0, X-position = 15, Y-position = -10, Rotation angle = 90,
Object No. = 1, X-position = 15, Y-position = 5, Rotation angle = 0
• Setting
Transmission data
Condition: Object No. = 0
• Readout
Transmission data
Response data
[Object No.], [X-position], [Y-position], [Rotation angle]
S
(, [Object No.], [X-position], [Y-position], [Rotation angle]...)
[Object No.]
R
Max. 4-byte
[Object No.], [X-position], [Y-position], [Rotation angle]
A
Data length
[byte]
Max. 4* "0000"–"1999"
Max. 8*
"-999.999"–"+999.999" [mm]
Max. 8*
Max. 8* "-180.000"–"+180.000" [°]
It is the length including the separator ",".
Max. 31 The maximum value that can be set to one object number.
Max. 32 objects can be set at once.
[STX] POS
[STX] POS
[STX] POS
(Check sum) End code
31-byte
Data contents
• The coordinate of the item omitted
• For the point radiation object, specify
S 0,15,-10,90,1,15,5,0
R 0 [CR]
A 0000,+015.000,-010.000,+090.000
ME-LPGS-SR-5
(Check
sum)
(Check
End code
sum)
Remarks
remains to be the value set last (the
initial value if it was not set).
X-/Y-offset and rotation angle applied
to the all radiation points set in the
specified object number.
[CR]
[CR]
End code
123