Bar Code/2D Code Settings Commands; Bar Code/2D Code Object Settings: Brf - Panasonic LP-GS Series Serial Communication Command Manual

3-7 Bar Code/2D Code Settings Commands

3-7-1 Bar code/2D code object settings: BRF

Sets the conditions such as the position and size of the bar code/2D code as well as code characteristics.
Reference
• If you want to change the object position only, use the object coordinate (POS) command or object movement (POR)
command as a shortened command.
• If you want to change the laser power or scan speed correction value of the bar code/2D code objects (except QR codes
and Data matrix codes) only, use the laser correction by object (MOD) command as a shortened command.
• To specify the module fill spacing of the bar codes or PDF417, use object group settings (GRP) command.
• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negative
response.
• Use the object creation (CRE) command if you want to create new bar code/2D code objects.
• The laser power correction and the scan speed correction set by this command will not apply to the human readable
text.
⿎ Setting request data / response data for readout
Start
BRF Sub command
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
BRF
code
⿎ Data description
1. When the code type is CODE39/ITF
Name Omit
Object No.
X-position
Y-position
Rotation angle
Code type (Y)
Bar code height
Narrow element
width
94
[Object No.], [X-position], [Y-position],
[Rotation angle], [Code type], [Various setting
data (vary depending on code type)]
R
Max. 6-byte (2D side of composite code)
Data
length
[byte]
– Max. 4* "0000"–"1999"
Y Max. 8*
"-999.999"–"+999.999" [mm]
Y Max. 8*
Y Max. 8* "-180.000"–"+180.000" [°]
"00": CODE39
2
"01":ITF
Model
LP-GS051(-L)
Y Max. 7* LP-GS052
LP-RC350S
LP-RF200P
Y Max. 5* "0.050"–"1.000" [mm]
[Object No.]
Max. 4-byte or
Data contents
Setting range [mm]
"000.050"–"055.000"
"000.050"–"030.000"
"000.050"–"085.000"
"000.050"–"090.000"
ME-LPGS-SR-5
(Check sum) End code
(Check sum) End code
Remarks
It is the center coordinate of
the code.
The rotation center is the
center of the code symbol.
Specify a larger value than the
line width in the object group
settings.