Step & Repeat Fine-Adjustment: Sra - Panasonic LP-GS Series Serial Communication Command Manual

3-11-9 Step & repeat fine-adjustment: SRA
Sets the fine-adjustment of "Step & repeat" to mark the same marking contents on multiple locations in one file.
Setting request data / response data for readout vary by the setting subject to fine-adjustment.
⿎ Readout request data
Start
SRA
code
⿎ Setting request data / response data for readout: when adjustment object is single step
Start Sub
SRA
code command
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Data description
Name Omit
Adjustment No.
Adjustment object
Object group No.
Target row
Target column
Adjustment item
X-movement
Y-movement
Z-movement
Rotation movement
136
[Adjustment No.]
R
Max. 3-byte
[Adjustment No.], [Adjustment object],
[Object group No.], [Target row], [Target column],
[Adjustment item], [X-movement], [Y-movement], [Z-movement],
[Rotation movement], [Laser power correction]
Data length
[byte]
– Max. 3* "000"–"999"
– 1 "1": Single step
– Max. 4* "0000"–"1999"
– Max. 3*
"001"–"400"
– Max. 3*
"0": Position/Power
– 1
"1": Mark OFF
Y Max. 8*
"-999.999"–"+999.999" [mm]
Y Max. 8*
Model
LP-GS051
LP-GS052
Y Max. 8*
LP-GS051-L
LP-RC350S
LP-RF200P
Y Max. 8* "-180.000"–"+180.000" [°]
(Check sum)
Max. 60-byte
Data contents
Setting range* [mm]
"-003.000"–"+003.000"
"-001.500"–"+001.500"
"+000.000" or omit
ME-LPGS-SR-5
End code
(Check End
sum) code
Remarks
Specifies an object group
number with Step & repeat set.
Enables the adjustment item for
the selected row/column.
If you specify "1": Mark OFF,
end the data here. It is not
necessary to transmit the
subsequent data including a
separator ",".
• Moves the coordinate of the
marking data in the range of
rows/columns specified.
• It is the movement for the
coordinate after executing
Step & repeat.
• Z-movement cannot be
specified with LP-GS051-L,
LP-RC and LP-RF series.