On-The-Fly Marking Commands; Motion Settings For All Files: Fly - Panasonic LP-GS Series Serial Communication Command Manual

3-12 On-the-fly Marking Commands

3-12-1 Motion settings for all files: FLY

Supported model: LP-RC series, LP-RF series
Sets the basic configuration of the on-the-fly marking, such as moving direction and etc. The settings are applied to all
marking files.
⿎ Setting request data / response data for readout
Start
FLY
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
FLY
code
⿎ Data description
Name Omit
On-the-fly marking
ON/OFF
Moving direction
Trigger mode
Trigger detecting
position
Line speed control
Encoder resolution
142
[On-the-fly marking ON/OFF], [Moving direction],
[Trigger mode], [Trigger detecting position],
Sub [Line speed control], [Encoder resolution],
command [Distance line speed sensors],
R (Check sum)
Data
length
[byte]
"0": OFF
– 1
"1": ON
"0": +X to -X
"1": -X to +X
Y 1
"2": +Y to -Y
"3": -Y to +Y
"0": Single trigger
"1": Marking at regular
Y 1
intervals
"2": Multiple triggers
Y Max. 8* "0000.000"–"1000.000" [mm]
"0": Fixed speed
Y 1 "1": Encoder input
"2": 2 sensors input
"005.000"–"600.000" [pulses/
Y Max. 7 *
mm]
[2 Sensors input time-out]
Max. 35-byte
End code
Data contents
The direction of X/Y axis is defined by the
head direction setting in System settings.
Specifies the distance from the center of the
marking field to the detecting position of the
trigger sensor.
If you specify "0": fixed speed, end the data
here. It is not necessary to transmit the
subsequent data including a separator ",".
Only when line speed control is set to
"encoder input", set this value.
For other line speed controls, omit this
setting.
ME-LPGS-SR-5
(Check
sum)
Remarks
• Specify ON to enable on-the-fly marking.
• If you specify "0" : OFF, end the data
here. It is not necessary to transmit the
subsequent data including a separator ",".
End
code