Status Checking: Sts - Panasonic LP-GS Series Serial Communication Command Manual

3-3-9 Status checking: STS

Reads out the laser marker status, such as marking trigger ready status and error occurrence status.
⿎ Readout request data
Start
STS
code
⿎ Response data for readout
Start
STS A
code
* This data is included only in the response data of LP-RC/LP-RF series.
⿎ Data description
Data length
Name
Marking trigger
ready state
Laser radiation
status
Laser pumping
status
Shutter status
Command
reception status
Error occurrence
status
(LP-RC/LP-RF
only)
Data waiting
status
Total data length 11 or 13
Reference
• For LP-GS series: "1,0,2,1,1,0" is the response data for status checking with the marking trigger ready ON.
• For LP-RC/LP-RF series "1,0,2,1,1,0,0" is the response data for status checking with the marking trigger ready ON.
68
R (Check sum)
[Marking trigger ready state], [Laser radiation status],
[Laser pumping status], [Shutter status], [Command reception status],
[Error occurrence status], [Data waiting status *]
Data contents
[byte]
"0": Marking trigger ready OFF
1
"1": Marking trigger ready ON
"0": Laser radiation OFF (no
marking operation)
1
"1": Laser radiation ON (marking
is in progress)
"0": Laser pumping OFF
1 "1": Laser pumping in preparing
"2": Laser pumping completed
"0": Shutter close
1
"1": Shutter open
"0": Command reception
permission ON
1
"1": Command reception
permission OFF
"0": No error
1
"1": Error occurrence
"0": Not in data input waiting
1
"1": In data input waiting
It is the length including the separator ",". The data length is fixed.
• LP-GS series: 11-byte
• LP-RC/LP-RF series: 12-byte
End code
LP-GS: 11-byte
LP-RC/LP-RF: 13-byte
Marking trigger can be input only with the marking
trigger ready ON.
Indicates the command reception permission
(MKM command) status. Use this for
determination of whether various commands can
be transmitted. For details, refer to "2-4 Command
Reception Condition" (P.44).
• When using either of the following functions,
this response data indicates the waiting status
of the data input. Confirm this response data is
"1" and then input the corresponding data.
• SIN command
• SEO command
• Registered characters (via I/O)
• External offset function
• When the above functions are not used, the
response data is always "0".
ME-LPGS-SR-5
(Check End
sum) code
Remarks