Applying Reference Character: Lno - Panasonic LP-GS Series Serial Communication Command Manual

3-5-5 Applying reference character: LNO

Applies the preset reference characters to the specified character object.
⿎ Setting request data / response data for readout
Start
LNO
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
LNO
code
⿎ Data description
Name Omit
Object No. –
First string No. to
–
apply
Last string No. to
Y
apply
Total data length
* Setting request data are variable length.
Reference
• If the object type set in the specified object number is not the character (Reference list type), the laser marker returns the
negative response.
• Use the object creation (CRE) command if you want to create new character objects (Reference list type).
• The reference characters cannot be used in character objects other than reference list type and bar code/2D code
objects.
⿎ Example of command settings
Condition: Object No. = 1, First string No. to apply = 101
• Setting
Transmission data
• Readout
Transmission data
Response data
84
[Object No.], [First string No. to apply],
Sub
[Last string No. to apply]
command
[Object No.]
R
Max. 4-byte
Data length
Data contents
[byte]
Max. 4* "0000"–"1999"
Max. 3*
"001"–"200"
Max. 3*
Max. 12 It is the length including the separator ",".
[STX] LNO
[STX] LNO
[STX] LNO
Max. 12-byte
(Check
End code
sum)
The object type set in the specified object number
should be the character (Reference list type).
• Select the string number from the preset reference
list.
• Applies all strings from the first string No. to the
last string No. to the specified object.
• Specify the smaller no. to the starting row no. than
the last string No.
• If you omit the last string No., only the string set in
the first string No. is applied to the object.
S 1,101 [CR]
R 1 [CR]
A 0001,101,101
ME-LPGS-SR-5
(Check
End code
sum)
Remarks
[CR]