Panasonic LP-GS Series Serial Communication Command Manual page 176

ERROR
CODE
Lasing stopped because the maximum number
E631
of scans was reached.
Lasing operation/shutter open operation was
cancelled due to a timeout after the laser start-
up check.
Try again.
E640 *3 (Details: For the first operation of opening shutter
E641 *3 or lasing after the laser pumping on, warning
E640/E641 may occur and the requested
operation is canceled in case the laser pumping
has been off for more than several days and time
for laser start-up check (maximum 30 seconds)
is needed.)
Font file data are incorrect. Unable to read the
E652
font file.
Graphic file data are incorrect. Unable to read
E653
the graphic file.
Font file is not registered to the font No.
E654
specified.
Insufficient font memory. Font file data capacity
E655
is too large.
E656 The specified graphic data are not registered.
No font corresponding to set characters were
E657
found.
E658 Too large number of characters.
E659 Existed invalid character for bolding with setting.
176
Description
ME-LPGS-SR-5
Measures *1
• Confirm the on/off control of the TRIGGER IN on
the I/O terminal.
• If TRIGGER IN turns on/off properly, change the
setting value of Maximum number of scans of
Trigger mode in File settings.
• When operating with Laser Marker NAVI smart,
retry to start test marking/laser radiation for
measurement/run mode operation.
• When operating in remote mode, close the shutter
or input the alarm reset to recover from the
warning status, and then retry opening the shutter
or laser radiation for measurement.
• Re-register font data on the data management
screen.
• Check the font data file format.
• Re-register graphic data on the data management
screen.
• Check the graphic data file format.
• Register the font file on the data management
screen.
• Using the character conditions, specify the font
No. in which the font file is registered.
• Reduce the number of characters registered in the
font file.
• Delete unnecessary font files.
Register the graphic file in the data management
screen.
• Change characters, or add the font data in use.
• To use Japanese or Simplified Chinese
characters, set "East Asian characters" in file
settings.
• Decrease the number of characters.
• Set the characters by separating them into several
objects.
• Original4 font cannot be displayed in bold. Select
another font.
• Use Font Maker software provided to create the
proper pattern font.