Marking End Verification: Mst - Panasonic LP-GS Series Serial Communication Command Manual

3-3-10 Marking end verification: MST

Enables automatic response of marking result (e.g. normal end, and error occurrence, etc.) at the end of marking.
For the communication sequence of this command, refer to "Communication sequence when the marking end verification
(MST) command response is enabled" (P.29).
⿎ Setting request data / response data for readout
Start
MST Sub command
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
MST
code
⿎ Data description
Data length
Name
Response setting
Total data length
Reference
• Once you set the response settings of the marking end verification, they are valid during the remote mode.
• When the marking end verification is used, set the response permission before every shifting to the remote mode. This
command setting will be restored to the response prohibited state once you deactivate the remote mode.
⿎ Automatic response data with response permitted
The following response data transmit normal end or abnormal end at the end of the trigger processing (marking) with the
marking end verification response permitted.
Start
MST
code
* This data is included only when the trigger mode is set to "continuous trigger".
⿎ Data description
Data length
Name
Status
[Response setting]
R (Check sum)
Data contents
[byte]
"0": Response prohibited
1
"1": Response permitted
1 The data length is fixed.
[Status], [Number of scans *]
A 3-byte
With continuous trigger setting: 8-byte
Data contents
[byte]
"000": Normal end
3 "001"–"999": Error code
(abnormal end)
(Check sum)
1-byte
End code
• It returns the error number occurred in case of an
abnormal end by an error during marking trigger
processing.
• When the warning that does not interrupt the
marking operation (E700 to E799) occurs, the
response data indicates "000" as the normal end.
ME-LPGS-SR-5
End code
Remarks
(Check sum) End code
Remarks
69