Object Management Commands; Object Creation: Cre - Panasonic LP-GS Series Serial Communication Command Manual

3-10 Object Management Commands

3-10-1 Object creation: CRE

Creates a new object by specifying the object number, object group that the object belongs, and the object type.
After creating a new object, specify the marking settings of the corresponding object by using other commands such as
STR, CDF etc.
⿎ Setting request data / response data for readout
Start
CRE
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
CRE
code
⿎ Data description
Name Omit
Object type –
Object No. Y
Object group No. Y
Total data length
* Setting request data are variable length.
Reference
• The readout request is valid only right after creating an object by the setting request.
• At the readout request, the laser marker returns the object number created last.
• TrueType objects cannot be created with this command.
120
[Object type], [Object No.],
Sub
[Object group No.]
command
Max. 11-byte
R (Check sum)
Data length
[byte]
"0": Character
"1": Graphic
1 "2": Bar code/2D code
"3": Character (Reference list type)
"4": Point radiation
Max. 4* "0000"–"1999"
Max. 4* "0000"–"1999"
Max. 11 It is the length including the separator ",".
(Check
sum)
End code
Data contents
ME-LPGS-SR-5
End code
Remarks
• If another object already exists at
the specified object number, the
laser marker returns the negative
response.
• If you omit this field, the object will
be created at the smallest object
number that is not in use.
• Specifies the object group number
that the created object belongs to.
• If you omit this field, the object
group number 0 will be set.