Step & Repeat Settings: Src - Panasonic LP-GS Series Serial Communication Command Manual

3-11-8 Step & repeat settings: SRC
Sets the condition of "Step & repeat" to mark the same marking contents on multiple locations in one file.
⿎ Setting request data / response data for readout
Start
SRC
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
SRC
code
⿎ Data description
Name Omit
Object group No.
Step & repeat
ON/OFF
Base position
Number of rows
Number of
columns
Row step
Column step
134
[Object group No.], [Step & repeat ON/OFF],
[Base position], [Number of rows],
Sub [Number of columns], [Row step], [Column step],
command [Count individually], [Count direction],
[Count "Mark OFF"], [Counter starting position]
[Object group No.]
R
Max. 4-byte
Data
length
[byte]
– Max. 4* "0000"–"1999"
"0": OFF
– 1
"1": ON
"0": Top left
"1": Top right
Y 1
"2": Bottom left
"3": Bottom right
Y Max. 4*
"0001"–"0400"
Y Max. 4*
Model
Y Max. 7*
LP-GS051(-L)
LP-GS052
LP-RC350S
Y Max. 7*
LP-RF200P
Max. 42-byte
(Check sum)
Data contents
Setting range [mm]
"000.000"–"055.000"
"000.000"–"030.000"
"000.000"–"085.000"
"000.000"–"090.000"
ME-LPGS-SR-5
(Check
End code
sum)
End code
Remarks
Specifies an object group
number with Step & repeat set.
• Specify ON to enable Step &
repeat.
• If you specify "0": OFF,
end the data here. It is not
necessary to transmit the
subsequent data including a
separator ",".
Specifies the marking data
position used as the base point
of Step & repeat.
• The number of rows indicates
the making data repeat
count for Y-direction, and the
number of columns indicates
that for X-direction.
• The upper limit of "Row x
Column" is 10000.
These are the interval for
placing the marking data of Step
& repeat.
The row step is the interval for
Y-direction while the column
step is that for X-direction.