Module Filling Of 2D Codes: Brt - Panasonic LP-GS Series Serial Communication Command Manual

3-7-3 Module filling of 2D codes: BRT

Sets the filling details of the 2D code (QR codes and Data matrix codes) modules.
Reference
• If the object type set in the specified object number is not the bar code/2D code, the laser marker returns the negative
response.
• The settings by this command are applied only to QR codes, micro QR codes, iQR codes , Data matrix codes and GS1
Data matrix codes. To specify the module fill spacing of the other codes, use object group settings (GRP) command.
⿎ Setting request data / response data for readout
Start
BRT
code
Sub command is "S" for the setting request data and the initial setting "A" for the response data for readout.
⿎ Readout request data
Start
BRT
code
⿎ Data description
1. Fill type is horizontal line/vertical line/horizontal raster/vertical raster
Name
Object No.
Code element
Fill type
Module marking
direction
Number of filling
lines
Module line length X
Module line length Y
Total data length
* Setting request data are variable length.
106
[Object No.], [Code element], [Fill type],
Sub
[Filling details (varies depending on fill type)]
command
[Object No.], [Code element]
R
Max. 6-byte
Data length
Data contents
[byte]
Max. 4* "0000"–"1999"
1 "0": Same in all elements
"01": Horizontal line
"02": Vertical line
Max. 2
"05": Horizontal raster
"06": Vertical raster
For horizontal line/horizontal raster
"0": Left to Right
"1": Right to Left
"2": Alternate (Left to Right)
1
For vertical line/vertical raster
"0": Top to Bottom
"1": Bottom to Top
"2": Alternate (Top to Bottom)
Max. 2 * "01"–"99" [modules]
Max. 5 *
"0.001"–"9.999" [mm]
Max. 5 *
Max. 26 It is the length including the separator ",".
Max. 26-byte
(Check
sum)
This item is fixed to "0" except when the fill
type is fonts.
ME-LPGS-SR-5
(Check
End code
sum)
End code
Remarks