X85; „ Power Saving - Konica Minolta CM-M6 Instruction Manual

Power saving
… „
The amount of time before switching to the Power saving mode can be set.
The Power saving is set to "0 (minute)" (Power saving is OFF) when the instrument is shipped from the factory.
Memo
Operating Procedure Start the procedure from the <Setting> - <Instrument setup> screen.
1
Use [] or [] to move the cursor to "Power
saving", and then press the [Confirmation] key.
The <Power saving> screen is displayed.
2
Use [] or [] to change the value.
Settings
00 to 60 minutes
{ „
If set to "00", power saving is off.
Memo
3
Press the [Confirmation] key to confirm, and then
press [ESC].
The selection is confirmed, and the screen returns to the
<Instrument setup> screen.
If [ESC] is pressed without pressing the [Confirmation]
Notes
key, the settings will not be changed, and the screen will
return to the <Instrument setup> screen.
• P ressing any of the operation keys will cause the
Memo
instrument to cancel Power saving mode.
• W hen the instrument is communicating with a PC using
the optional SpectraMagic DX software, Power saving
mode cannot be enabled.
Sample
0002 TARGET-2
Setting
Instrument setup
Power saving
0 (minute)
Sample
0002 TARGET-2
Setting
Instrument setup
Power saving
Power saving
0 (minute)
0 0 / 6 0
3
96