Warning Level Setting; Parametric Coefficient Setting - Konica Minolta CM-M6 Instruction Manual

Warning Level Setting

… „
The warning level is set to "80%" under the initial settings.
Memo
Operating Procedure Start the procedure from the <Setting> - <Default data setup> screen.
1
Use [] or [] to move the cursor to "Warning
level", and then press the [Confirmation] key.
The <Warning level> screen is displayed.
2
Use [] or [] to change the value.
Settings
000 to 100%
{ „
3
Press the [Confirmation] key after completing the
changes.
The setting is confirmed and the screen returns to the
<Default data setup> screen.
If [ESC] is pressed during configuration, the settings will
Notes
not be changed and the screen will return to the
<Default data setup> screen.

Parametric Coefficient Setting

… „
• The parametric coef. is set to "1.00" under the initial settings.
Memo
• Parametric coefficients can be edited only when the difference equation is "CMC", "ΔE*94", or "ΔE00".
Operating Procedure Start the procedure from the <Setting> - <Default data setup> screen.
1
Use [] or [] to move the cursor to "Parametric
coef.", and then press the [Confirmation] key.
The <Parametric coef.> screen is displayed.
Sample
0002 TARGET-2
Setting
Default data setup
Default tolerance
Warning level
80%
Parametric coef.
Sample
0002 TARGET-2
Setting
Default data setup
Warning level
Default tolerance
Fail
Warning level 0 8 0
%
80%
Pass
Parametric coef.
Sample
0002 TARGET-2
Setting
Default data setup
Default tolerance
Warning level
80%
Parametric coef.
3
82