Handling the Instrument
Cleaning the Components
This section explains how to clean the target mask and the inside of the integrating
sphere.
Target Mask
• If the target mask become dirty, gently wipe the dirt off using a cloth soaked in water or
soapy water. Never use solvents such as thinner or benzene.
• If the inside becomes dirty, blow off the dirt or dust using a blower.
Notes
Do not touch the inside of the target mask or use a cloth to wipe off dust or
dirt on the mask. If the target mask is dirty, and the dirt cannot be removed
by a blower or the like, contact a KONICA MINOLTA-authorized service
facility.
Inside the Integrating Sphere
Procedure
❶
Remove the target mask.
Memo
See page E-15, "Attaching/Removing the
Target Mask" for how to remove the target
mask.
❷
Use a blower to blow off dust or dirt inside the
integrating sphere.
Notes
Do not touch, use a cloth to wipe off dust
or dirt, or put anything inside the
integrating sphere. If the inside of the
integrating sphere is dirty, and the dirt
cannot be removed by a blower or the like,
contact a KONICA MINOLTA-authorized
service facility.
(Cont.)
Turning the Power ON/OFF
Turning the Power ON
❶
Press and hold
second.
The display on the LCD screen will
appear and the READY lamp will
illuminate in blue.
Turning the Power OFF
❶
If the power is ON, press and hold
POWER
The display on the LCD screen will
disappear.
Memo
• When shipped from the factory, the buzzer sound and READY lamp are set to
• The buzzer sound when the power is turned ON or when measuring can be
Target
mask
POWER
for about 1
BEEP BEEP!
for about 1 second.
ON.
changed to OFF using the PC application settings for the instrument. For
details, see "*Settings Only Confi gurable from the PC Application" under Other
Settings on pages E-57–58.
16
Power button