White Calibration - Konica Minolta CM-M6 Instruction Manual

Table of Contents

White Calibration

„

This instrument requires white calibration before performing measurement after the power is turned ON and

before performing measurement for the first time.

• If the calibration interval is turned ON and a time is configured, a message prompting white calibration will be

Memo

displayed the next time the power is turned ON only after the set time has passed since the previous white

calibration. (Refer to page 85 "Calibration Interval Messages".)

• The reading may fluctuate slightly due to changes in the ambient temperature or due to heat generation caused by

repeated operation of the instrument. In such cases, perform white calibration regularly.

• White calibration must be performed at the same temperature at which measurement will be performed.

Notes

• Perform white calibration after the instrument has had time to adapt to the ambient temperature.

Operating Procedure

Start the procedure from the measurement screen.

Although white calibration can be performed from the prompt when the power is turned ON and from the screen

following zero calibration, the following explains the procedure to perform white calibration from the

measurement screen.

Press [MENU], and then use [] or [] to display the

<Calibration> screen.

• The following screen prompting calibration is

Notes

displayed when the instrument starts up.

When power is turned ON

Use [] or [] to select "White calibration", and

then press the [Confirmation] key.

Attach the white calibration cap to the instrument

while referring to page 20 "White Calibration

Cap".

Calibration